90-8M0174152 eng APRIL 2021 © 2021 Mercury Marine Page 1 / 5
SMARTCRAFT CONNECT GATEWAY
MANUAL
IMPORTANT: This document guides our dealers, boatbuilders, and company service personnel in the proper installation or
service of our products. If you have not been trained in the recommended servicing or installation procedures for these or
similar Mercury Marine products, have the work performed by an authorized Mercury Marine dealer technician. Improper
installation or servicing of the Mercury product could result in damage to the product or personal injury to those installing or
operating the product.
Components in Kit
NOTE: The termination band on the 10‑pin connector cable only applies to under cowl mounted modules.
a - SmartCraft CONNECT module
b - SmartCraft CONNECT module ‑ side view
c - Cable ties ‑ 4
d - #10 x .88" stainless steel wood screw
Features
The CAN P, CAN H, and NMEA lights will turn on when data is being transmitted through the Gateway.
NOTE: This manual covers the installation of CAN P only ‑ engine mounted module (single). The helm mount module will
default out of the box to CAN P, and must be dealer or OEM configured to use CAN H. CAN H is applicable to Dual, Triple,
and Quad DTS engine applications.
71911
TERMINA
TED
ENGINE MOUNT ONL
Y
To Next Page
Need help?
General
