Mercury SmartCraft CONNECT User Manual

SMARTCRAFT CONNECT GATEWAY MANUAL
Page 2 / 5 © 2021 Mercury Marine 90-8M0174152 eng APRIL 2021
SmartCraft CONNECT Module—Single‑ through Quad‑Engine
NOTE: The Connect module does not provide power for any device on the NMEA 2000 network. The NMEA 2000 network
will require its own power source. The NMEA 2000 network power input must have appropriate circuit protection for the
devices on the NMEA 2000 network.
NOTE: The termination band on the 10‑pin connector cable only applies to under cowl mounted modules.
a - CAN P connection light
b - NMEA connection light
c - CAN H connection light
d - Wi‑Fi connection light
e - Bluetooth® connection light
f - NMEA 2000® connector
g - 10‑pin connector
Module Harness Connections
1. Connect the SmartCraft CONNECT module in one of the two following ways:
a. Connect the CAN 10‑pin harness connector to the SmartCraft junction box. Refer to the following diagram.
b. Connect the CAN 10‑pin harness connector to the helm harness SmartCraft 10‑pin connection using a male‑male
adapter harness.
TERMINA
TED
ENGINE MOUNT ONL
Y
a
b
d
e
c
f
g
71912

Mercury SmartCraft CONNECT Specifications

General

Brand	Mercury
Model	SmartCraft CONNECT
Category	Gateway
Language	English