PAGE 12
POWER:
This switch delivers the A.C. power to the Express Plus. Make sure the unit is properly grounded (all three terminals
of the A.C. power cord must be connected whenever possible and that the proper voltage is present. Follow the cold start procedure
described in the ON/STANDBY section above when powering up your new Express Plus amplifier.
NOTE: Never alter the A.C. power cord in any way.
STANDBY:
Perfect for set breaks...this toggle switch also serves an even more important purpose. In the STANDBY position (switch
left), the tubes are at idle so that during power up they may warm up before being put to use.
Before the power is switched on, make sure the STANDBY switch is in the STANDBY position. Wait at least 30
seconds and then flip the STANDBY switch to its ON position. Following this simple warm up procedure helps in prevent-
ing tube problems and increase their toneful life substantially.
Now let’s spin your Express Plus around and cover the Rear Panel Features.
FrONT PANeL: CONTrOLS & FeATureS (Continued)
REST AREA
To Next Page
Loading...
Need help?
General
