Metabo HPT DB 3DL2 User Manual

14
English
9. Using the light
The light lights when the light switch is pushed.
When the light switch is pushed again, the light
is turned off . (Fig. 12)
Light switch
Fig. 12
CAUTION
Do not look directly into the light. Such
actions could result in eye injury.
10. Using in the straight or pistol grip
Select the grip type that best matches the tool
application. When changing the grip type, the
tool will make a clicking sound when it snaps
into position. Bend (or extend) the tool until the
clicking sound is heard.
CAUTION
● Do not place your fi ngers or any portion
of your body in or near the bending
portion of the tool while operating the
tool or while bending and straightening
the tool because you may be pinched in
the bending portion resulting in possible
injury.
● Do not remove the rubber cover around the
bending portion.
● If the rubber cover becomes loose,
damaged or lost, contact your metabo HPT
AUTHORIZED SERVICE CENTER. (Fig. 13)
Bending portion
Fig. 13
THE SCOPE AND SUGGESTIONS
FOR USES
Table 6
Work Cap position Suggestions
Drilling
Steel
Use for drilling purpose.
Aluminum
Screw tightening
Small screw 1 – 21
Use the bit and socket matching the screw
diameter.
Wood screw
1 –
Use after drilling a pilot hole.
CAUTION
● While operating the cordless driver drill,
take care not to lock the motor.
If the motor is locked, immediately turn the
power off .
If the motor is locked for a while, the motor
or battery will be burnt.
● Do not tighten too strongly as the screw
heads will be damaged.
000BookDB3DL2NA.indb14000BookDB3DL2NA.indb14 2018/09/2111:25:112018/09/2111:25:11

Metabo HPT DB 3DL2 Specifications

General

Brand	Metabo HPT
Model	DB 3DL2
Category	Drill
Language	English