8
Voltage
With Auto on the LCD, press the SELECT button 3 times to select V ac
function. The meter displays LoZBV when it is ready.This function is
auto-ranging.
With Auto on the LCD, press the SELECT button 4 times to select V dc. The
meter displays LoZ V when it is ready. This function is auto-ranging.
Resistance
With Auto on the LCD, press the SELECT button 5 times to select resistance
function, The meter displays MΩ when it is ready. This function is
auto-ranging.
Frequency
With Auto on the LCD, press the SELECT button 6 times to select frequency
function, The meter displays Hz when it is ready. This function is
auto-ranging.
Capacitance
With Auto on the LCD, press the SELECT button 7 times to select
capacitance function, The meter displays nF when it is ready. This function
is auto-ranging.
Return to Auto
Press the SELECT button 8 times to return to AutoTect test mode.
V dc, V ac, and Line-Level Hz
Turn the rotary switch to the V position to select common impedance
Hi-Z voltage measurements. V dc is the default function. Press SELECT
button momentarily to select V ac. The AC annunciator B appears. Press
momentarily again to select the Line-Level Hz function.
Line-Level Hz input sensitivity varies automatically with V ac range selected
when Line-Level Hz is selected. Measuring the signal in V ac function
WHILE selecting Line-Level Hz function in that V ac range automatically sets
the most appropriate sensitivity for higher voltage applications. This can
avoid electrical noises as in 110/220 V line voltage applications. For
example, If the reading shows zero due to insufficient signal levels, select
Line-Level Hz function BEFORE making measurements (at 6 V ac range) will
set the highest sensitivity.
To Next Page
Loading...
Need help?
General
