Chapter II X02137C00 - Ed. 1 - 06/07
Intrinsically safe portable digital multimeter
27
∗
If any faults or abnormalities are observed, take the instrument out of service and
ensure that it cannot be used until it has been checked out.
∗
It is recommended to remove the battery from the instrument if not used.
1.2. Protection devices
ASYC II series instruments are fitted with various protection devices :
∗
A protection by varistors allows a chopping of transient overvoltages present at
the terminals of measurement.
∗
A PTC (Positive Temperature Coefficient) resistor protects against permanent
overvoltages of up to 600 V during resistance, capacitance and diode test
measurements. This protection is reset automatically after overload.
∗
One F1 intrinsically safe fuse provides protection during current measurements.
∗
A special intrinsic safety case ensures IP 67 sealing.
1.3. Safety devices
∗
The battery unit and fuse cannot be accessed without first disconnecting the
measuring leads.
∗
When measuring voltages above 24 V, the sign blinks on the display.
∗
If the maximum range is repeatedly exceeded, an intermittent audible signal indicates
the risk of electric shock.
1.4. Warranty
This equipment is warranted against any defects of manufacture or materials according to
the general conditions of sale.
During the warranty period (3 years), defective parts will be replaced, the manufacturer
reserving the right to repair or replace the product. In the event of the equipment being
returned to the after sale department or to a local agency, carriage to the centre shall be
payable by the customer.
The warranty does not cover the following :
1. Repairs necessitated by misuse of the equipment or use in association with
incompatible equipment.
2. Modification of the equipment or any related software without the explicit authorization of
the manufacturer.
3. Repairs necessitated by attempts to repair or maintain the product made by a person
not approved by the manufacturer.
4. Adaptation to a specific application not provided for in the specifications of the
equipment or the user manual.
5. Damage after a drop, a shock or flooding.
The contents of this manual must not be reproduced in any form whatsoever without the
consent of the manufacturer.
To Next Page
Loading...
Need help?
General
