Midea C01 User Manual

18
Malfunction
code
Reason Description Solution
E10
Inlet water
overtime
The water level
doesn’t changed in 3
minutes during filling
the water.
Open the water tap, to check if the
inlet hose is squashed or kinked,
check the filter in the inlet valve is
blocked or not; check if the water
pressure is too low.
E12
Overflow
The water level is
higher than the
overflow water level.
Check the water inlet valve, Valve fail
E20
Fault connection
of the drain pump
The
water level
doesn’t changed in 3
minutes during drain
the water.
Check the drain pump.
Check the filter of the drain pump
to prevent jam.
Check the drain hose to prevent
jam.
E21
Overtime 3min
of the drainage
The
water level.
Overtime draining
E30
The door has not
been closed over
3 times
Fail to lock the door
lock for 6 times when
the PCB ties to lock the
door lock after you
press the Start keys.
Check the door hook and the door
lock to get correct location.
E31
Don’t unlock the
door lock
Fail to unlock the door
lock 6 times
Check the door Lock
E33
Water level
sensor fail
The frequency of the
water level sensor is
out of the spec.
Check the water level sensor
E34
Temperature
sensor fail
The temperature
sensor(NET) get broken
Check the PCB and the motor
E60
The motor don’t
drive
The motor don’t drive
for
5 times
Water temperature sensor
cutting
-
out
Check the PCB and the motor
Check the motor communicate
wire
E61
The speed don’t
transmit signal
The PCB can’t get
speed transmit signal
when the motor drive
Check the speed transmit line of
the motor to prevent fall
of
Check the PCB and the motor
Check the motor communicate
wire
4 MALFUNCTION CODES AND EXPLANATIONS
Schedule of failure alarm

Midea C01 Specifications

General

Brand	Midea
Model	C01
Category	Washer
Language	English