Use the remote controller within a distance of 5
meters from the appliance, pointing it towards
the receiver. Reception is confirmed by a beep.
Location of the remote controller.
5m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block the signals
from the remote controller to the unit.
Prevent any liquid from falling into the remote controller. Do not expose the remote
controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains to prevent direct sunlight on the
receiver.
If other electrical appliances react to the remote controller, either move these
appliances or consult your local dealer.
HANDLING THE REMOTE CONTROLLER
Installation instructions of battery
Step 1: Insert a coin vertically in the groove
on the battery cover, clockwise rotation of 45
degrees, make sure that the groove is aligned
with the "unlock" sign
and remove the battery cover.
as shown below
Step 2: Install battery inside the remote
controller, the positive (+) side up.
Step 3: Install the battery cover, make
sure the battery cover groove
nsert a coin
vertically in the groove and press it
gently, then counter clockwise rotation
of 45 degrees, make sure the groove is
is aligned
with the "unlock" sign. I
aligned with the "lock" sign as shown
below.
Coin
Battery cover
Groove
Lock sign
Unlock sign
Groove
Unlock sign
Battery cover
Battery
Positive (+) side up
Coin
Groove
Battery cover
Unlock sign
Lock sign
Coin
Groove
Battery cover
Unlock sign
Lock sign
Lock sign
Coin
WARNING
1. Battery must be disposed of properly. Do not
short circuit or dispose of in the fire.
2. Keep batteries out of the reach of children.
3. Caution for ingestion.
4. Non-rechargeable batteries are not to be
recharged.
5. Exhausted batteries are to be removed from
the product.
7 8
To Next Page
Loading...
Need help?
General