15
REMOVING COLLECTED WATER
When Your Bucket Is Full
Type 1: Bucket drainage
There are different ways to remove collected water.
Bucket drainage
Type 1:
Type 3:
Pump drainage
(only for pump model)
Type 2:
Water hose drainage
(continuous)
• When the unit is off, if the bucket is full, the Full indicator light will turn on.
• When the unit is on, if the bucket is full, the comoressor and the fan turn off, and the Full indicator light
will turn on, the digital display shows P2.
• Pull the bucket out halfway, then pull up the handle and lift the bucket slowly vertically to prevent spillage.
• Dump the water and replace the bucket. The bucket must be correctly installed for the dehumidifier to operate.
• The appliance will re-start when the bucket is restored in its correct position.
1
Pull the bucket out halfway.
Do not pull out the whole bucket without grabbing the handle, or it may cause damage to the bucket or
even injure you.
WARNING
2
Pull up the handle and lift
the bucket slowly vertically.
3
Pour the water out.
To Next Page
Loading...
Need help?
General
