The display board is
damaged.
Replace the display
board.
Some buttons can’t work,
or the LED display is not
normal.
The display board is
damaged.
Replace the display
board.
The Cooking Mode
Indicator comes on, but
heating does not start.
High temperature of the
hob.
Ambient temperature
may be too high. Air
Intake or Air Vent may be
blocked.
There is something
wrong with the fan.
Check whether the fan
runs
smoothly；
if not , replace the fan.
The power board is
damaged.
Heating stops suddenly
during operation and the
display flashes “u”.
Use the proper pot (refer
to the instruction
manual.)
Pan detection
circuit is damaged,
replace the power
board.
Pot diameter is too
small.
Unit is overheated. Wait
for temperature to return
to normal.
Push “ON/OFF” button to
restart unit.
Heating zones of the same
side (Such as the first and
the second zone) would
display “u” .
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
Replace the display
board.
The Main board is
damaged.
Fan motor sounds
abnormal.
The fan motor is
damaged.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction hob.
9. Installation
9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated
work surface material (Wood and similar fibrous or hygroscopic material shall not be used as work surface
material unless impregnated) to avoid the electrical shock and larger deformation caused by the heat
radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop
should be at least 3mm.
To Next Page
Loading...
Need help?
General
