AC Fan Coil Unit Two-pipe Wall-mounted Series
- 33 -
13. Controller
13.1 Wireless remote controller R51/E
13.1.1 Remote Controller Specifications
Model R51/E
Rated Voltage 3.0V
Lowest Voltage of CPU Emitting Signal 2.0V
Reaching Distance 8m (when using 3.0 voltage, it can get 11m)
Environment Temperature Range
-5℃~60℃
13.1.2 Introduction of Function Buttons on the Remote Controller
1 TEMP DOWN Button:
Push the TEMP DOWN button to decrease the indoor temperature setting or to adjust the timer in a counter-
clockwise direction.
2 MODLE Select Button:
Each time you push the button, a mode is selected in a sequence that goes from AUTO, COOL, DRY, HEAT and
FAN as the following figure indicates:
Note: HEAT only for Heat Pump.
3 SWING Button:
Push this switch button to change the louver angle.
4 RESET Button:
When the RESET button is pushed, all of the current settings are cancelled and the control will return to the initial
settings.
5 ECONOMIC Running Button:
Push this button to go into the Energy-Saving operation mode.
6 LOCK Button:
Push this button to lock in all the current settings. To release settings, push again.
7 CANCEL Button:
Push this button to cancel the TIMER settings.
AUTO COOL DRY HEAT FAN
To Next Page
Loading...
Need help?
General
