TroubleshootingWasher CareWasher Use
Washer
Safety
Operation
Requirements
Installation
Instructions
• IMPORTANT - Save these instructions for local
inspector’s use.
•
IMPORTANT - Observe all governing codes and
ordinances.
• Note to Installer - Be sure to leave these instructions with the
Consumer.
• Note to Consumer - Keep these instructions for future reference.
• Skill level - Installation of this appliance requires basic mechanical
and electrical skills.
• Completion time - 1-3 hours.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under the
Warranty.
WARNING
• This appliance must be properly grounded and installed as described
in these Installation Instructions.
• Do not install or store the appliance in an area where it will be
exposed to water/weather. See the Location of Your Washer section.
• NOTE: This appliance must be properly grounded, and electrical
service to the washer.
• Certain internal parts are intentionally not grounded and may present
a risk of electric shock only during servicing. Service Personnel - Do
not contact the following parts while the appliance is energized:
Electrical Valve, Drain Pump, Heater and Motor.
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read these instructions completely and carefully.
FOR YOUR SAFETY:
TOOLS REQUIRED
• Adjustable wrench or 3/8 “ & 7/16 “ socket with ratchet
• Adjustable wrench or 9/16 “ & 3/8” open-end wrench
• Channel-lock adjustable pliers
• Carpenter’s level
8
To Next Page
Need help?
General