R410A 50Hz Tropical Split AC MCAC-UTSM-2012-12
134
4. Heat Insulation of the Pipe
4.1 Heat Insulation of the Pipe
In order to prevent faults caused by condensate of the refrigerant pipe and drain pipe, perform condensate
prevention and heat insulation properly.
CAUTION:
If it is forecast that high humidity/temperature environment (condensate temperature is over 23℃) may exist in the ceiling, e.g.,
inside the ceiling with slab, ceiling which is in the same environment as the outdoor air), it is necessary to apply 10mm or thicker
adiabatic wool (16~20kg/m2 ) to the refrigerant pipe and the drain pipe in addition to applying the general heat insulation
materials. Enough heat insulation materials should also be applied to the refrigerant joint and the pipe joint.
4.2 Heat Insulation of the Drain Pipe
Be sure to entwine heat insulation materials round the drain pipe which runs through the room.
Carry through heat insulation for the drain pipes thoroughly.
4.3 Heat Insulation of the Refrigerant Pipe
Please use heat-resistant materials as heat insulation materials of the air-side pipe. (e.g., EPT)
Cover heat insulation materials separately at the liquid side and the air side. Moreover, perform heat
insulation thoroughly for the air-side pipes of the indoor unit, and prevent water from dripping outside the
unit.
To Next Page
Loading...
Need help?
General
