Buttons and Funcitons
04
SLEEP
Saves energy during sleeping
hours.
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how
to operate your air conditioner, refer to the
How to Use Basic Functions section of this manual.
ON/OFF
SET
Turns the unit on or off.
MODE
OK
LED
Scrolls through operation modes
as follows:
AUTO
COOL
DRY
HEAT FAN
TIMER ON
TIMER OFF
Increases temperate in
1°C increments.
Max. temperature is
30°C.
Model:
RG10F(B)/BGEF （Fresh feature is not available）
RG10F1(B)/BGEF
TEMP
TEMP
Used to confirm the selected
functions.
Decreases temperature
in 1°C incr
ements.
Min. temperature is
17°C.
Sets timer to turn unit off
(see How to Use Basic
Functions for instructions).
Turns indoor unit’s LED display and
air conditioner buzzer on and off
(model dependent), which create a
comfortable and quiet environment.
The selected symbol will
flash on the display area,
press the OK button to
confirm.
Sets timer to turn unit
on (see How to Use Basic
Functions for instructions).
SHORTCUT
Used to restore the current
settings or resume previous
settings.
I SENSE
Press this button to activate the
I SENSE mode.
SWING
FAN SPEED
Selects fan speeds in the
following order:
AUTO LOW MED HIGH
Starts and stops the horizontal
louver movement. Hold down
for 2 seconds to initiate vertical
louver auto swing feature.
NOTE: Please do not select
HEAT mode if the machine you
purchased is cooling only type.
Heat mode is not supported by
the cooling only appliance.
Scrolls through operation
functions as follows:
Fresh( ) AP mode( )
Fresh...
To Next Page
Loading...
Need help?
General
