PRODUCT INSTALLATION
Installation and Connection
1. This appliance is only intended for domestic use.
2. This oven is intended for built-in use only. It is not intended for counter-top use or for
use inside a cupboard.
3. Please observe the special installation instructions.
4. The appliance can be installed in a 60cm wide wall-mounted cupboard.
5. The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket.
6. The mains voltage must correspond to the voltage specified on the rating plate.
7. The socket must be installed and connecting cable must only be replaced by a
qualified electrician. If the plug is no longer to accessible following installation, an all-
pole disconnecting device must be present on the installation side with a contact gap
of at least 3mm.
8. Adapters, multi-way strips and extension leads must not be used. Overloading can
result in a risk of fire.
The accessible surface may be hot during operation.
To Next Page
Loading...
Need help?
General
