3 4
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions section of this manual.
ON/OFF
Turns the unit on or off
MODE
Scrolls through operation
modes as follows:
AUTO
g
COOL
g
DRY
g
HEAT
g
FAN
FAN SPEED
Selects fan speeds in
the following order:
AUTO g LOW g
MED g HIGH
SLEEP
Saves energy during
sleeping hours
TURBO
Enables unit to reach
preset temperature in
shortest possible time
TEMP
p
Increases temperate in
O
1 C increments.
Max. temperature is
O
30 C .
TEMPq
Decreases temperate in
O
1 C increments.
Min. temperature is
O
17 C .
TIMER ON
Sets timer to turn unit
on (see How to Use
Basic Functions for
instructions)
TIMER OFF
Sets timer to turn unit
off (see How to Use
Basic Functions for
instructions)
SWING
Starts and stops louver
movement
LED
Turns indoor unit s LED display on and off.
,
FOLLOW ME
Temperature sensing
and room temperature
display button.
SELF CLEAN
Starts and stops
self clean feature.
NOT SURE WHAT A FUNCTION DOES?
Refer to the How to Use Basic Functions and
How to Use Advanced Functions sections
of this manual for a detailed description of
how to use your air conditioner.
SPECIAL NOTE
Button designs on your unit may differ
slightly from the example shown.
If the indoor unit does not have a particular
function, pressing that function s button
on the remote control will have no effect.
When there are wide differences between
Remote controller Illustration and
USER'S MANUAL on function description,
the description of USER'S MANUAL
shall prevail.
TIPS FOR USING REMOTE CONTROL
Inserting and Replacing Batteries
Y
our air conditioning unit comes with two
batteries. Put the batteries in the remote control
before use.
1. Slide the back cover from the remote
control downward, exposing the battery
compartment.
2. Insert the batteries, paying attention to match
up the (+) and (-) ends of the batteries with
the symbols inside the battery compartment.
3. Slide the battery cover back into place.
BATTERY NOTES
For optimum product performance:
Do not mix old and new batteries, or
Batteries of different types.
Do not leave batteries in the remote control
if you don t plan on using the device for
more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for
proper disposal of batteries.
,
,
ON/OFF
TEMP
TIMER
ON
TIMER
OFF
MODE
FAN
SLEEP
SWING
DIRECT
TURBO
CLEAN
LED
FOLLOW
If you are sensitive to light when you go to
sleep, you can press the LED button to turn
off the LED display on the indoor unit. Press
the button again to turn it back on.
Function Buttons
Handling The Remote Controller
,
,
,
,
,
,
,
,
,
,
,
,
NOTE:Please do not select
HEAT mode if the machine you
purchased is cooling only type.
Heat mode is not supported
by the cooling only appliance.
MODEL:RG57A6(B)/BGEF
SILENCE
FP
SILENCE/FP
Used to activate silence
O
and 8 C heating feature.
The remote control must be used within 8
meters of the unit.
The unit will beep when remote signal is
received.
Curtains, other materials and direct
sunlight can interfere with the infrared
signal receiver.
Remove batteries if the remote control
will not be used more than 2 months.
Prevent any liquid from falling into the
remote controller.
If other electrical appliances react to the
remote controller, either move these
appliances or consult your local dealer.
R03/LR03