Midea RG58N2(B2H)/BGEF User Manual

11
12
The FOLLOW ME function enables the
remote control to measure the temperature
at its current location and
.
When using AUTO, COOL, or HEAT modes,
measuring ambient temperature from the
remote control (instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around
you and ensure maximum comfort.
send this signal
to the air conditioner every 3 minutes interval
FOLLOW ME function( )(optional)
SLEEP Function( )
Active Clean Function( )
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
This function is used to clean the air
conditioner evaporator to prevent frosting.
When this function is turned on, the indoor
unit display window appears CL , after 20
to 45 minutes, the unit will turn off automatically
and cancel Active Clean function.
Note: The SLEEP function is not available
in FAN or DRY mode.
,
How To Use The Advanced Functions
Press the SET button to enter the function
setting, then press SET button or
Temp or
Temp button to select the desired function.
The selected symbol will flash on the display area,
press the OK button to confirm.
To cancel the selected function, just perform
the same procedures as above.
For the detail, see sleep operation in
USER S MANUAL.
,
,,
,
,
,
,
,,
,
,
,
,
SET
Current
time 1PM
2PM 3PM
4PM 5PM
6PM 7PM 8PM 9PM
Timer starts
Unit turns Unit turns
ON
OFF
6 hours later
8 hours later
The device could comply with the local national regulations.
In Canada, it should comply with CAN ICES-3(B)/NMB-3(B).
In USA, this device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for compliance
could void user s authority to operate the equipment.
NOTE:
Press the SET button to scroll through
operation functions as follows:
Active clean ( ) Sleep( ) Follow Me( )
gg

Midea RG58N2(B2H)/BGEF Specifications

General

Brand	Midea
Model	RG58N2(B2H)/BGEF
Category	Remote Control
Language	English