Midea V8 Series Engineering Data

V8 Mini R410A VRF 50Hz
60
Midea V8 Mini Series Engineering Data Book
2 Unit Placement and Installation
2.1 Outdoor Units
2.1.1 Placement considerations
Placement of outdoor units should take account of the following considerations:
 Air conditioners should not be exposed to direct radiation from a high-temperature heat source.
 Air conditioners should not be installed in positions where dust or dirt may affect heat exchangers.
 Air conditioners should not be installed in locations where exposure to oil or to corrosive or harmful gases, such as
acidic or alkaline gases, may occur.
 Air conditioners should not be installed in locations where exposure to salinity may occur unless the anti-corrosion
treatment for high-salinity areas customization option has been added and the precautions described in Part 3, 9
“Installation in Areas of High Salinity” are taken.
 Outdoor units should be installed in well-drained, well-ventilated positions that are as close as possible to the indoor
units.
2.1.2 Spacing
Outdoor units must be spaced such that sufficient air may flow through each unit. Sufficient airflow across heat exchangers
is essential for outdoor units to function properly. Figures 3-2.1 to 3-2.3 show spacing requirements in three different
scenarios.
Figure 3-2.1: Single unit installation (unit: mm)
Figure 3-2.2: Parallel connect the two units or above (unit: mm)
Figure 3-2.3: Pparallel connect the front with rear sides (unit: mm)
> 300
> 2000
> 300
> 600
(Wall or obstacle)
Air outlet surface
Air inlet surface
Air inlet
surface
Maintenance
cable and
pipeline surface
Fixed with a bolt
> 600
> 600
> 2000
> 300
> 2000 > 500 > 3000 > 3000 > 300

Midea V8 Series Specifications

General

Brand	Midea
Model	V8 Series
Category	Air Conditioner
Language	English