Turning on the appliance
NOTE
When you press the Start/Reset button to pause during washing,the
dishwasher will beep every minute unless you press the Start/Reset
button to start.
Starting a wash cycle...
Draw out the basket(see the section entitled "Loading the Dishwasher").
Pour in the detergent (see the section“Fill the detergent”).
Insert the plug into the socket. The power supply is 220-240VAC 50Hz, the
specification of the socket is 10A 250V AC.
Press the power button to turn on the appliance,
Connect the inlet hose to the tap, make sure that the water supply is turned on
to full pressure, or add water the the tank manually.
select a suitable program according to the “Wash cycle table”;
If a program is selected, the corresponding light will be lit. Then press the
Start/Pause button, the dishwasher begins to start.
Premise: You can modify the washing program, if the dishwasher just worked for
a short time. Otherwise, the detergent may have already been released, and the
appliance may have already drained the wash water in this case, the cycle
must be restarted.
Change the programme
23
Saving Energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption
and is not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and
water in the use phase than hand dishwashing when the household dishwasher is
used according to the instructions.
To Next Page
Loading...
Need help?
General
