Miele B 1312 User Manual

Setting the water hardness
level
Water hardness is programmed using
the control panel on the tower.
The programming procedure can be
cancelled at any time by pressing
the On/Off button s. The procedure
can then be re-started from the
beginning again.
Programme the water hardness as
follows:
^ If the appliance is on, switch it off
using the s button.
^ Press and hold the j button and at
the same time switch the appliance
on using the s button. Hold in the j
button until the k indicator lights up
yellow.
If this does not happen, start the
procedure again from the beginning.
The k indicator light flashes rapidly 10
times at intervals and the k indicator
light flashes slowly on and off (factory
default).
The water hardness set is shown by the
flash frequency of the k indicator light
(see table for water hardness).
^
Briefly press the j button to select
the number of flashes which equates
to your water hardness level.
Each press of the button moves you
up a level. When the highest water
hardness value is reached, the
setting starts from the beginning
again.
Please set the correct water hardness
level, as otherwise this invalidates the
guarantee.
Example:
Water hardness = 4.0 mmol/l (22°dH).
– The k indicator light will flash rapidly
10 times at intervals (factory default
setting).
– Press the j button 6 times.
– The k indicator light flashes rapidly 6
times.
^ Switch the appliance off with the s
button.
Checking the programmed
water hardness level
^
If the appliance is on, switch it off
using the s button.
^
Press and hold the j button and at
the same time switch the appliance
on using the s button. Hold in the j
button until the k indicator lights up
yellow.
The k indicator light will flash the
number of times which corresponds to
the water hardness level which has
been set (see table).
^
Switch the appliance off with the s
button.
Before using for the first time
22

Miele B 1312 Specifications

General

Brand	Miele
Model	B 1312
Category	Iron
Language	English