Brush attachment
The steamer comes with a brush
attachment which can be clipped onto
the head.
The steamer can be held directly on the
textile with the brush attached.
Always try it out on an unobtrusive
part of the fabric first.
The brush attachment helps to raise
and straighten the fibres.
^
Hold the brush attachment in front of
the steamer so that the lugs on one
side fit into the notches on the
steamer and click them into place.
^
Guide the brush attachment into the
notches on the opposite side and
click these into place.
^
To remove the brush attachment, pull
it by the raised section off the
steamer.
Steamer
35
To Next Page
Loading...
Need help?
General
