Unwinding / Rewinding (see fig. 9)
a Hold the plug and pull out the power
cord.
,
To reduce the risk of electric
shock, the vacuum has a polarized
plug (one blade is wider than the
other). This plug will fit in a polarized
outlet only one way. If the plug does
not fit fully in the outlet, contact a
qualified electrician. Do not alter the
plug in any way.
Danger of overheating and damage.
^ Unplug the vacuum from the outlet.
b Press the rewind switch - the power
cord will rewind automatically. Hold
the plug so that it does not whip
around when rewinding.
Adjusting the Electro Telescopic
suction wand (see fig. 10)
One part of the electro telescopic wand
is fitted inside the other and can be
adjusted to your height for comfortable
vacuum cleaning.
^
Press the telescopic wand release
button to release the tubes and
adjust to the desired height.
Turning the vacuum On/Off (see fig. 11)
^
Press the On/Off foot switch s.
Adjusting the suction (see fig. 12 + 13)
,
To prevent static electricity your
hand must touch the metal inlay on
the underside of the vacuum hand
piece. Be certain to continuously
touch this inlay when vacuuming
fine dust, flour or sawdust as these
materials are more likely to create a
static discharge. To further prevent
static discharge while vacuuming,
pull the vacuum along by the hose
with one hand while continuing to
hold the hand piece in the other
hand.
You can adjust the suction power to suit
the type of flooring. By reducing the
suction power the floor brush can be
pushed easier.
The symbols on the controls indicate
the type of use the settings are suitable
for.
# curtains, lightweight fabrics
$ upholstery, cushions
% thick pile carpets, rugs and runners
* energy saving, daily vacuuming
with low noise level
( low pile carpets
) hard flooring and intensive
cleaning of carpets
^
Turn the suction power selector to the
desired setting.
en
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
