Mains connection cable
104
Before connecting the coffee machine,
make sure that the connection data on
the data plate (voltage and frequency)
matches the mains electricity supply.
This data must correspond in order to
avoid the risk of damage to the coffee
machine. If in any doubt, consult a
qualified electrician.
The required connection data is given
on the data plate. The data plate can be
seen on the left-hand side of the
machine when the drip tray is pulled
out.
The machine is supplied with a mains
cable with moulded plug for connection
to a 50 Hz 220-240V supply.
The coffee machine must be connected
to the mains supply via a suitable
switched socket with earthing contact.
Connection must comply with national
and local safety regulations (BS 7671 in
the UK).
The fuse rating must be at least 10 A.
The socket should be next to the
appliance and easily accessible where
possible.
Do not connect the coffee machine to
the mains electricity supply using a
multi-socket adapter or an extension
lead. These do not guarantee the
required safety of the machine (fire risk).
Do not connect the coffee machine to
an off-grid inverter. These devices are
used for autonomous power supply,
e.g. a solar power system. Power
surges could cause a safety shutdown.
This could damage the electronic
module.
The coffee machine must not be used
with “energy saving plugs”. These
reduce the amount of energy supplied
to the machine, causing it to overheat.
If the mains connection cable is faulty,
it must only be replaced by a qualified
electrician in order to avoid a hazard.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
