Fit the wall units and extractor hood
before fitting the appliance to avoid
damaging the surface.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance may only be used in
mobile installations such as ships if a
risk assessment of the installation has
been carried out by a suitably qualified
engineer.
~
After installation, ensure that the
connection cable is without hindrance
and that there is no mechanical
obstruction which could damage it,
such as a drawer.
~
If an interim shelf is installed under
the appliance, there must be a
minimum gap of 40 mm between the
top of the shelf and the underside of the
appliance.
~
This appliance must not be installed
over a dishwasher, washing machine,
tumble dryer, refrigerator or freezer.
The high temperatures radiated by
hobs could damage the appliance
below.
All dimensions in this instruction booklet
are given in mm.
Safety instructions for installation
33
To Next Page
Loading...
Need help?
General