Time display
The duration of the programme
selected appears in hours and minutes
in the Time display before the
programme begins. During the
programme the time left until the end of
the programme is displayed.
The time displayed may vary with the
same programme. This is partly
because of the water temperature at
each intake, and partly because of the
amount of crockery and how dirty it is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit takes the new conditions
into account, and calculates the time
required.
Programme sequence
indicators
After a programme has been started
the current stage of the programme is
indicated by the programme sequence
indicator lights.
At the end of a programme
A programme has finished when a "0"
appears in the Time display and the
"End" programme sequence indicator
lights up.
The dishwasher can now be opened
and unloaded (see "Unloading the
dishwasher").
,
To prevent the risk of steam
damage to the worktop edging
above the dishwasher, it is advisable
to leave the door closed until you are
ready to unload the crockery.
Alternatively you can open the door
fully until the crockery is cool
enough to unload. Do not leave the
door only partially open.
Switching off
At the end of a programme:
^ Switch the dishwasher off with the
On/Off button s.
The dishwasher will continue to use
electricity until it is switched off with
the On/Off button s.
If the dishwasher is not going to be
used for a longer period of time, e. g.
whilst on holiday, the stopcock should
be turned off.
Operation
34
To Next Page
Loading...
Need help?
General
