Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
;? in, and whilst holding it in
switch the dishwasher on using the
On button U.
Keep the programme selector button
;? pressed in until the lower right
hand programme indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
^
Press the programme selector button
;? three times briefly.
The Inlet/drain check light 2/2 will
flash briefly three times at intervals.
The upper right hand programme
indicator will flash briefly three times at
intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the upper right
hand programme indicator flashes tells
you the rinse aid dosage which has
been set (see chart).
Rinse aid
in ml
Flashing
0-
1 Once
2 Twice
3 Three times
4 Four times
5 Five times
6 Six times
^ Press the programme selector button
;? for at least one second until the
upper right hand programme
indicator comes on.
^
Press the programme selector button
;? briefly to select the number of
flashes which equates to the rinse aid
dosage you want.
Each press on the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^
Switch the dishwasher off with the Off
button V.
Before using for the first time
22
To Next Page
Loading...
Need help?
General
