Programming and setting the
water hardness level
Your water hardness level must be pro
-
grammed into the machine using the
buttons on the control panel. The water
hardness level selector in the wash
cabinet is then also
set to the water
hardness level in your area.
Programming and changing the wa
-
ter hardness level
^
Turn off the dishwasher with the
“On/Off” button.
^ Turn the program selector to “Stop”.
^ Hold the “Start” button in and at the
same time turn the dishwasher on
with the “On/Off” button. Release the
“Start” button within 2 seconds.
The “Salt” indicator flashes.
Note:
If any other indicator lights flash or light
the process must be repeated.
Except:
If the “Rinse aid” indicator flashes or
lights then rinse aid was never added
or needs to be refilled.
^
Turn the program selector to your
corresponding water hardness level
(see table below).
gr/gal ppm Selector
Settings
1 - 4 20 - 70 Normal 55 °C/130 °F
5 - 7 90 - 130 Sani Wash
8 - 10 140 - 180 Normal 65 °C/150 °F
11 - 14 200 - 250 “4 o’clock” position
15 - 17 270 - 310 “5 o’clock” position
18 - 21 320 - 380 “6 o’clock” position
22 - 35 400 - 630 “7 o’clock” position
36 - 70 650 - 1260 “8 o’clock” position
The water hardness selector is preset
to 1 - 4 gr/gal (20 – 70 ppm).
Example:
For a water hardness level of
20 gr/gal.
Turn the program selector to the
“6 o’clock” position.
Before using for the first time
14
To Next Page
Loading...
Need help?
General
