^
Press the “Top Solo” button.
The “Top Solo” indicator will light.
^
Turn the program selector to “Stop”.
^
Turn “Off” the dishwasher with the
“On/Off” button.
The water hardness level is now stored
in the program memory.
Setting the water hardness level se
-
lector in the wash cabinet
The water hardness level selector in the
wash cabinet must be set according to
the following table.
Selecting the correct setting wil help
minimize the effects of dishwashing on
glass surfaces. Too high a setting will
lead to poor cleaning results and an in-
crease in water spots left on dishes and
cutlery.
^ Use a screwdriver to take the cover
off the water hardness level selector
in the wash cabinet.
^
Use a coin or screwdriver to adjust
the water hardness level selector in
the wash cabinet. There is a click as
each setting is reached.
gr/gal ppm Selector Setting
1- 7 20 - 130 3
8-10 140 - 180 2
11-14 200 - 250 1
15-70 270 - 1260 0
The selector setting is preset to “3”.
Example:
The water hardness level is 8 gr/gal.
The selector setting is 2 (8 - 10 gr/gal).
^
Replace the cover on the water hard
-
ness level selector.
Before using for the first time
15
To Next Page
Loading...
Need help?
General
