Operation
48
Display of program duration
The estimated duration of the selected
program appears on the display before
the program begins. During the pro-
gram, the time left until the end of the
program is displayed.
Each program phase is indicated by a
symbol:
Pre-rinse/Soak
Main wash
Interim rinse
Final rinse
Drying
Finish
The displayed duration may vary for the
same program. It is influenced by, for
example, the temperature of the incom-
ing water, the reactivation cycle of the
water softener, the detergent type, the
amount of dishware, and how soiled it
is.
When a program is selected for the first
time, the display will show the average
program duration for a cold water con-
nection.
The program durations shown under
“Program overview” refer to standard
test loads and temperatures.
Each time a program is run, the control
module calculates the program duration
required depending on the temperature
of the water taken into the dishwasher
and the amount of dishes.
Starting a program
The dishwasher can only be started if
the door is closed.
Press the Start button.
If necessary, confirm the previously
displayed message with OK.
The program starts.
The Start indicator light will come on.
During the course of the program, you
can use OK to display the name of the
program which is currently running.
Risk of scalding due to hot wa-
ter.
During operation, water in the dish-
washer may be very hot.
During operation, only open the door
with extreme caution.
To Next Page
Need help?
General
