With the aid of the following guide, minor problems can be easily corrected
without contacting Miele.
,
Installation, maintenance and repairs may only be carried out by a suitably
qualified and competent person in strict accordance with current national and
local safety regulations.
Repairs and other work by unqualified persons could be dangerous. The
manufacturer cannot be held liable for unauthorised work.
Ensure current is not supplied until after maintenance or repair work has been
carried out.
Problem Possible cause and remedy
The oven does not
heat up.
–
Check that the function selector and the temperature
selector have been set at the function and temperature
required.
– Check whether the mains fuse has tripped. If it has not,
contact a qualified electrician or Miele.
The heating works
but not the oven
lighting.
The lamp needs changing.
^ Disconnect the appliance from the electricity supply.
Switch off and unplug at the socket, or disconnect the
mains fuse, or switch off at the isolator as appropriate.
^ Unscrew the lamp cover and the seal.
^
Change the lamp.
When purchasing a new lamp, take the old one with you
to make sure you obtain the correct replacement (230 V,
25 W, E 14, heat resistant to 300 °C).
^
Screw the lamp cover and the seal back on again.
A noise can be
heard after a
cooking process.
This is not a fault.
The cooling fan continues to run for a while after the oven
has been switched off to prevent any humidity building up
in the oven, on the control panel or on the oven housing
unit. When the temperature has fallen sufficiently, the fan
switches off automatically.
The temperature will fall faster with the oven door open.
Problem solving guide
48
To Next Page
Loading...
Need help?
General
