Miele H 5040 BP - Triangle V in the Display

Triangle V in the display
I60
% m TS
V
When a sensor is touched, the
symbols of functions which can be
altered will light up in the display.
These will vary depending on
programme.
Touch the V or W sensor repeatedly
until triangle V is underneath the
symbol of the required function.
Then select the function using the OK
sensor.
Triangle V will flash for approx.
5 seconds.
You can only make entries with the V
or W sensors whilst triangle V is
flashing.
If the triangle has stopped flashing,
you will need to call up the function
again with the OK sensor.
The following will change each time the
V or W is touched
–
Duration T and Finish time S in
increments of a minute,
–
the Minute minder time N, at first in
increments of 5 seconds and then in
increments of a minute.
Touching the sensor for longer, speeds
up the change in the display.
Controls
19