Waterproof system
All Miele dishwashers have a safety
valve located on the incoming water
line and a sealed underside with a
water sensor.
If a fault occurs, the water intake is
stopped and the drain pump is
activated. Water damage, if any, is
minimized.
Providing the dishwasher was installed
correctly by a Miele technician, the
waterproof system will protect you from
water damage throughout the lifetime of
the machine.
Connection to the water
supply
,Do not drink water from the
dishwasher!
– The dishwasher can heat its own
water to the temperature required by
the wash program. This allows for
connection of the machine to either a
hot or cold water source. For lowest
energy consumption connect the
dishwasher to a cold water source.
For fastest possible wash times, with
slightly higher energy consumption,
connect the dishwasher to a hot
water source. All programs use hot
water in the rinse cycles.
–
The inlet hose is approximately 5 ft.
(1.5m) long.
–
A 5 ft. (1.5m) drain extension is
available from Miele.
–
The water inlet hose comes
equipped with a 3/4" female hose
thread connector. This can be
directly connected to a water supply
with 3/4" MHT (male hose thread
ends).
–
Water pressure: Must be between
4.5 - 145 psi (0.3 - 10 bar).
,
To prevent damage to the
dishwasher, it must only be
connected to a fully vented drainage
system.
,
Do not cut the intake hose. It
contains electrical wiring. If the hose
is cut, the dishwasher will not work.
There will be a water leak and you
could be injured. If the hose is too
long, coil it neatly and place it
behind the machine.
Plumbing
54
To Next Page
Loading...
Need help?
General
