Building under
Where the building under height is
820 mm the appliance can be pushed
straight into the niche. Align the
appliance beforehand using the
adjustable feet.
Where the building under height is
870 mm the adjustable feet will first
have to be extended by approx. 50 mm
using a spanner (SW 30) or suitable
screwdriver. Then align the appliance.
^
Position the power supply cable so
that it can easily be connected to the
electricity socket once the appliance
has been built in.
^
Fit fixing bracket a into position and
secure it with self-tapping screws b.
^
Place the appliance on the slides
supplied and push it into the niche.
These make it easier to push the
appliance in or pull it out.
^
Align the appliance with
neighbouring furniture housing units.
^ Loosely secure the appliance to the
worktop through fixing bracket a.
The appliance is properly secured to
the worktop only after the plinth
depth has been adjusted and the
furniture door has been fitted to the
appliance.
Adjusting the plinth depth
^
Loosen screws a by turning them
approx. 8 to 10 times.
^
Align the plinth fascia to
neighbouring furniture plinths.
Building in the appliance
33
To Next Page
Loading...
Need help?
General
