The appliance is supplied right hand
hinged. If left hand door hinging is re
-
quired follow the instructions below.
^
Open the lower appliance door.
^ Use a screwdriver to lever the plinth
fascia a out, then pull it forwards
and off.
^ Use a screwdriver to remove cover
b, then close the door.
^
Remove screw c completely.
^
Pull door support d together with
hinge pin e downwards, then tilt it
forwards and take it off.
^
Open the lower appliance door, move
it downwards and take it off.
^
With the upper door g closed, pull
hinge pin f downwards to remove it.
^ Open the upper door, and pull it
downwards and off. Take care not to
lose the washers b.
^ Unscrew upper hinge pin a using
the spanner supplied and refit on the
opposite side.
^
Exchange cover g in the middle of
the appliance with hinge bracket d.
To do this:
Undo screws h, pull cover g and
hinge bracket d off to the side, turn
around and refit into position on the
opposite side.
^
Pull bearing bush c downwards out
of hinge bracket d and refit it from
above into the hinge bracket.
^
Remove spacer f with a screwdriver
and refit it on the opposite side.
^
Remove plugs i from door bearing
bushes in the doors and refit on the
opposite side.
Changing the door hinging
37
To Next Page
Loading...
Need help?
General
