Commissioning
18
Display functions
General
The display is used to select or set the
following:
– the programme
– the delay start time
– settings
During a programme, the display shows
the following:
– the programme stage
– the estimated time left for the
programme to run
– any relevant fault messages and
information
To save energy, the dishwasher will
switch to Standby mode within a few
minutes if no programme is running
and no button is pressed. After several
more minutes it will switch off
completely (see "Operation,
Standby").
Press the button to switch the
dishwasher back on.
Settings menu
The Settings menu is used to alter the
dishwasher's electronics to suit
different requirements.
You can access the Settings menu by
pressing a specific button combination.
See "Settings menu" for more details.
In the Settings menu, the normal
functions of the buttons underneath the
display are not active allowing you to
select and confirm menu options with
these buttons.
The arrows on the left and right of the
display indicate that further options are
available. You can use the arrow
buttons underneath the display, as
appropriate, to select these further
options.
Use the middle button underneath the
display to confirm messages or settings
and to switch to the next menu or
submenu.
A tick will appear beside the option
which is currently selected.
To Next Page
Loading...
Need help?
General
