Transit fittings
The transit fittings, 2 at the front and 2 at the back are
each secured in position with 3 hex screws. These
have to be removed on-site before the machine can
be commissioned.
To do so the front panel and the rear panel of the
machine have to be removed. Unscrew the screws
from the bottom edge of the front panel and then take
the front panel off.
Unscrew the screws from the back panel and then
take the back panel off.
Store the transit fittings in a safe place for future
use. They will need to be refitted should the
machine ever be moved to another location.
Installation and connection
33
To Next Page
Loading...
Need help?
General
