Always make sure the vacuum
cleaner is unplugged and the
Powerbrush is disconnected from
the vacuum before attempting to
clean or service the Powerbrush.
To remove threads or hair wrapped
around the roller:
^
Cut the threads or hair using a pair of
scissors. The pieces will be drawn
into the Powerbrush by the suction
power of the vacuum the next time it
is used.
Stubborn tangles or other objects
can be removed as follows:
^ Loosen the two lock screws on the
bottom of the Powerbrush using a
coin or screwdriver and remove the
roller cover.
^
Pull up the roller brush until it
releases from the main housing, and
slide the drive belt over the end of
the brush. The roller brush and roller
brush compartment can now be
cleaned.
en - Maintenance and Care
21
To Next Page
Loading...
Need help?
General
Weight and Dimensions
