en-US
8
Frequently asked questions
The Electrobrush switches itself off.
The overheating protection mechanism
has been activated due to overheating
or a blockage.
Turn off the vacuum cleaner and un-
plug it.
Check the vacuum cleaner for any
blockages and check all the filters in
the vacuum cleaner.
The Electrobrush has to cool down. To
speed up this process:
Reconnect the vacuum cleaner and
switch it on.
The Electrobrush will be ready for use
again after about ten minutes.
Maintenance
Removing threads and hairs
(Fig. 10)
Always disconnect the vacuum
cleaner from the power supply for
maintenance work and for cleaning.
Switch off at the wall socket and un-
plug it.
Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush.
To guide the scissors, move along the
guide track in the roller.
Then, run the vacuum cleaner to vac-
uum up the cut pieces.
To Next Page
Loading...
Need help?
General
