Note
Drum lighting
The drum interior is lit by a heat resistant bulb.
Replacement bulbs should only be ordered
from your Miele dealer or the Miele Spare
Parts department. The light bulb must not
exceed the maximum wattage quoted on
the data plate and on the light cover.
To replace the bulb switch off the machine
at the mains switch.
Open the drum door.
Unscrew the cover inside the drum above
the door by hand.
Exchange the bulb and screw the cover
back on.
The cover must be fixed securely, as other-
wise moisture may seep in and cause a
short circuit.
To open the door in the event of a power
failure.
Only use the flap opener supplied to open
the door.
Air inlet opening
The air inlet opening is at the rear of the ma-
chine. Under no circumstances must this inlet
be blocked. Avoid placing any covers or cloths
on the lid of the machine which could hang
down and obscure the inlet.
cover
bulb
13 «M.-Nr.04832650/02 - GB - »
To Next Page
Loading...
Need help?
General
