Rear view
a Protruding lid for holding when
moving the machine (see arrows)
b Air inlet vent for cooling the
condenser unit
c Mains connection cable
d External drainage of the condensed
water
e Accessories for connection to a sink
drain outlet
Installation site
,
The machine lid must not be
removed.
The dryer can be pushed under a
worktop with its lid in place, providing
the worktop is high enough.
,
The appliance must not be
installed behind a lockable door, a
sliding door or a door with a hinge
on the opposite side to that of the
tumble dryer, in such a way that a
full opening of the tumble dryer door
is restricted.
Transporting the machine to its
installation site
,
Important. The cavity under the
lid which can be seen when the
condensed water container is
removed must not be used to carry
or lift the machine. This could
damage the machine.
Do not hold the machine by the door
to carry it.
When moving the machine, hold it by
the lid where it protrudes to the rear of
the dryer. To manoeuvre the dryer out
of its packing case to its installation site
you will also need to hold it by the front
feet.
Washer-dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. The
appropriate "WTV" stacking kit
(available to order) to match your dryer
is required.
,
Stacking kits must only be
installed by a suitably qualified fitter.
Installation and connection
36
To Next Page
Loading...
Need help?
General
