Problem Possible cause Remedy
The Clean the filters
indicator light comes on
at the end of the
programme.
This is a reminder to
clean the fine filter in front
of the heat exchanger unit
under running water.
–
Clean the fine filter.
See "Cleaning and
care".
To switch off this
reminder:
–
Switch the dryer off
and then back on
again.
–
Open and shut the
door with the dryer
switched on.
The Empty container
indicator light comes
on.
The buzzer sounds.
The condensed water
container is full or there is
kink in the drain hose.
–
Empty out the
condensed water
container.
– Check the drain hose.
To switch off this
warning:
– Open and close the
door.
The Start/Stop button is
flashing slowly and the
display is dark.
The dryer is in Standby
mode.
This is quite normal and
not indicative of any fault.
See "Programmable
functions".
The Start/Stop button
flashes/does not flash.
The flashing indicates
that a programme can be
started.
After the programme has
started, the flashing will
change to a constant
light.
Problem solving guide
35
To Next Page
Loading...
Need help?
General