Top-up rinse for Cottons
At the end of the main wash addi-
tional water flows into the drum and
the suds are cooled down.
Hot suds can damage plastic drainage
pipes.
Top-up rinse takes place when tem-
peratures of 95°C and 75°C are se-
lected.
Before the "Top-up rinse for Cottons"
programmable function can be se-
lected you must first select programm-
ing mode.
Selecting programming mode
1 The machine must be switched off
and the drum door closed. The pro-
gramme selector must point to "Fin-
ish".
2 Press the additional option buttons
"Short" and "Water plus" at the same
time and hold pressed in and:
3 . . . switch the machine on with the
“I-ON/0-OFF”-button.
4 Let go of all these buttons.
The indicator light "Main wash" flashes
in the sequence display.
Selecting the programmable function
To select the "Top-up rinse for Cottons"
programmable function turn the pro-
gramme selector to –
DELICATES cold ***.
Activating
To activate "Top-up rinse for Cottons"
press the "START" button once.
The "Rinses" light comes on in the se-
quence display.
Storing in memory
To store the "Top-up rinse for Cottons"
programmable function in the memory
SWITCH the machine OFF with the
“I-On/0-OFF" button.
The "Top-up rinse for Cottons" pro-
grammable function is now stored in
the machine’s memory.
Deactivating
If the "Top-up rinse for Cottons" pro-
grammable function is no longer re-
quired it can be deactivated. To do so
repeat the procedure given above from
point
1 as far as the *** shown above.
Press the START button and the
“Rinses” indicator light will go out. The
function is now deactivated. Store in
memory by pressing the I-On/0-Off but-
ton.
Programmable functions
36
To Next Page
Loading...
Need help?
General
