Levelling the machine
The machine must stand perfectly level
on all four feet to ensure safe and
proper operation.
Incorrect installation may increase elec-
tricity and water consumption and may
cause the machine to move about.
The four adjustable screw feet are used
to level the machine. All four feet are
screwed in when the machine is deliv-
ered.
Screwing out and adjusting the feet
^
Gently tip the machine and prop it up
using a solid wooden wedge for ex
-
ample, to ensure stability.
Make sure the machine does not slip
as this could cause injury.
^
With a screwdriver loosen and turn
the foot 1 together with the
counternut 2 to the left, (see illustra-
tion below) and screw out.
^ Put the machine back on all four feet.
^ Use a spirit level to check the ma-
chine is standing level.
^ Hold the foot 1 firm using a pipe
wrench and turn the counternut 2 to
the right firmly up against the housing
with a screwdriver.
All four counternuts must be firmly
up against the housing. Please also
check this for the feet which did not
need adjustment. Otherwise there is
the danger of the machine moving
about.
Installation
54
To Next Page
Loading...
Need help?
General
