1.
2.
3.
The power consumption under maximum load can reach 14 W.
PoE version accepts 12-57 V DC with maximum consumption 18W, with attachments 66 W.
Connecting to a PoE Adapter:
Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter;
Connect an Ethernet cable from your local network (LAN) to the PoE adapter;
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Power output
Applies only to OmniTik 5 PoE ac:
This device can supply PoE power to external devices from its Ethernet ports. This is convenient as you don't need any
additional PoE injectors to power other devices. The output voltage will be the same as the input voltage. The Maximum power output of each Ethernet
port in this mode is 1A (total maximum for all ports is 2A). To reach maximum output power it is recommended to use a high voltage adapter together with
the included PoE injector to power the OmniTik unit (48/56V), because 802.3af/at the input is limited to 30W and OmniTik will consume up to 15W by itself.
Once Power Output is enabled in RouterOS, the Ethernet LED adds red color to it (green means Ethernet link is made, red means power but no link, red
and green both means there is link and power).
Mounting
On the back of the device, slide the included pole mount adapter with the clip facing forward, until the clip clicks into place.
Use the included hose clamp to attach the unit to a pole or mast. Adjustable QuickMount adapters are available separately.
The OmniTik has a locking screw that secures the port door, it can be closed with a 5mm hex screwdriver.
Grounding
The installation infrastructure (towers and masts), must be properly grounded.
Please secure all loose Ethernet cables and antenna cables to the pole or mast approximately 30cm from the device, so that the cable weight is
not pulling the ports and connectors.
To Next Page
Loading...
Need help?
General
