Defibrillator/Monitor Quick Reference Guide
BeneHeart D3/BeneHeart D2
Indicators are described from left to right:
AC power indicator
Illuminated: when AC mains is connected.
Off: when AC mains is not connected.
Battery indicator
Yellow: when the battery is being charged.
Green: when the battery is fully charged or the equipment is run on battery.
Off: when no battery is installed or battery fails.
Status indicator
Flashing: when a failure is detected, or when battery is not installed if No
Battery is configured as Status Indicator ON.
Off: when the equipment operates properly.
Status indicator
Illuminated: when AC mains is connected, and the equipment operates
properly.
AED Mode
1.
Plug the pads cable in the equipment's therapy port.
2.
Apply multifunction electrode pads to the patient.
3.
Turn the Mode Select knob to AED.
4.
Follow the screen and voice prompts.
5.
Press the Shock button, if prompted.
Manual Defibrillation
1.
Plug the therapy cable in the equipment's therapy port.
2.
Apply multifunction electrode pads or external paddles to the patient.
3.
Turn the Mode Select knob to Manual Defib.
4.
Select energy if necessary.
5.
Press the Charge button on the front panel or external paddles.
6.
Press the Shock button on the front panel or external paddles.
Alarm lamp
Indicators
Navigation knob
Lead Select
button
External paddles
Mode Select
knob
Shock
button
Charge
button
Main Menu button
Energy
Select
knob
To Next Page
Need help?
General
