Mindray BeneHeart D2 Quick Reference Guide

0 4 6 - 0 1 0 8 6 4 - 0 0 ( 1 . 0 )
Noninvasive Pacing
Demand Mode:
1.
Apply multifunction electrode pads and ECG leads.
2.
Turn the Mode Select knob to Pacer.
3.
Press the Lead Select button to select the best lead.
4.
Verify that white R-wave markers appear above the QRS complexes. If
the R-wave markers do not appear or do not coincide with the R-wave,
select another lead.
5.
Rotate the Navigation knob to adjust the pacer rate, then press the
knob in. If necessary, select initial pacer output.
6.
Press the Start Pacing soft key to start pacing.
7.
Verify that white pacing markers appear on the ECG waveform.
8.
Adjust pacer output until cardiac capture occurs.
9.
Verify the presence of a peripheral pulse.
Fixed Mode:
1.
Turn the Mode Select knob to Pacer.
2.
Switch the pacer to the Fixed mode.
3.
If ECG electrodes are applied, press the Lead Select button to select
the desired lead.
4.
Adjust pacer rate or pacer output. If necessary, select initial pacer
output.
5.
Press the Start Pacing soft key to start pacing.
6.
Verify that white pacing markers appear on the ECG waveform.
7.
Adjust pacer output until cardiac capture occurs.
8.
Verify the presence of a peripheral pulse.
Synchronized Cardioversion
1.
Plug the therapy cable in the equipment's therapy port.
2.
Apply multifunction electrode pads or external paddles to the patient.
3.
Turn the Mode Select knob to Manual Defib.
4.
Press the Enter Sync soft key to activate the function.
5.
Press the Lead Select button to select the best lead. The selected lead
should have a clear signal and a large QRS complex.
6.
Verify that the white R-wave markers appear above R-waves. If the
R-wave markers do not appear or do not coincide with the R-waves, for
example above the T-waves, select another lead.
7.
Select energy if necessary.
8.
Press the Charge button on the front panel or external paddles.
9.
Press the Shock button on the front panel or external paddles, release
it until discharge is complete.
Alarm Status Symbols
indicates alarms are paused. indicates alarm are reset.
indicates alarm sounds are turned off.
indicates the system is in alarm off status.
User Test
Before every use, checks shall be done to ensure that the equipment is
ready for operation at any time.
1.
Press the Main Menu button.
2.
Select the User Test >> soft key.
3.
Select the Start soft key.
4.
Routine Test is ticked by default. If necessary, select Energy Delivery
and Controls Test.
5.
Follow the screen prompts.

Mindray BeneHeart D2 Specifications

General

Brand	Mindray
Model	BeneHeart D2
Category	Medical Equipment
Language	English