Mindray iMEC 10 User Manual

7
Getting Started
Turning Power On
Before you start to make measurements, check the patient
monitor for any mechanical damage and make sure that
all external cables, plug-ins and accessories are properly
connected.
Plug the power cord into the AC power source. If you run the
patient monitor on battery power, ensure that the battery is
sufciently charged.
Press the power on/off switch on the monitor’s front. The start-up
screens are displayed, and the alarm lamp is lit in yellow. Then,
the alarm lamp turns into red and turns off after the system gives
a beep.
The monitor enters the main screen.
Decide which measurements you want to make.
Connect the required patient cables and sensors.
Check that the patient cables and sensors are correctly
connected.
Check that the patient settings such as [Patient Cat.], [Paced],
etc, are appropriate for your patient.
Refer to the Operator's Manual for details of how to perform the
measurements you require.
1.
2.
3.
4.
1.
2.
3.
4.
5.
Starting Monitoring
Disconnecting from Power
To disconnect the patient monitor form the AC power
source, follow this procedure:
Conrm that the patient monitoring is nished.
Disconnect the patient cables and sensors from the
patient monitor.
Make sure to save or clear the patient monitoring
data as required.
Press and hold the power on/off switch. The patient
monitor shuts down and you can unplug the power
cable.
1.
2.
3.
4.
Note
:
Make sure that the operating environment of the
patient monitor meets the specic requirements.
Otherwise unexpected consequences, e.g.
damage to the equipment, could result.
Do not use the patient monitor for any monitoring
procedure on a patient if you suspect it is not
working properly, or if it is mechanically damaged.
Contact your service personnel or us.


Basic Operations

Mindray iMEC 10 Specifications

General

Brand	Mindray
Model	iMEC 10
Category	Measuring Instruments
Language	English