10
g. Extend the Lower and Middle Shafts to suit the selected
demining position as shown in Figure 6. For use in the standing
position:
Figure 6: F3 in the Standing, Kneeling or Prone Positions
Open the Lower Camlock and rotate the coil to the desired
position. The normal operating position of the coil is in line with
the shaft. However, the coil can also be positioned at right angles
to either side of the shaft (required if the F3 is to be used in the
prone position). Once the position of the coil is selected, lock it
into position by closing the Lower Camlock.
To Next Page
Loading...
Need help?
General
