EasyManuals Logo
Home>Minelab>Metal Detector>F3 Mine Detector

Minelab F3 Mine Detector User Manual

Minelab F3 Mine Detector
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
14
2.5 Changing Endcaps.
The F3 can be used with Black, Red or Yellow Sensitivity Endcaps.
The decision on which Endcap to use will be provided by the local
authority. To fit a Sensitivity Endcap:
a. Ensure the F3 is switched off.
b. Place the thumb of one hand in the centre of the Endcap and curl
the fingers under the base of the Endcap.
c. Gently push inwards with the thumb and simultaneously pull the
base of the Endcap away from the Electronics Pack (Figure 11).
d. Exchange or replace the Endcap by gently positioning the inside
of the base of the Endcap under the base of the Electronics Pack.
Using the palm of the hand, apply light pressure to fit the Endcap
into position.
Figure 11: Removing a Sensitivity Endcap
**WARNING**
The Sensitivity Endcap also provides impact protection to
the Electronics Pack. Whenever an Endcap has been
removed from the Electronics Pack never place the base of
the detector against the ground or sharp objects.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Minelab F3 Mine Detector and is the answer not in the manual?

Minelab F3 Mine Detector Specifications

General IconGeneral
BrandMinelab
ModelF3 Mine Detector
CategoryMetal Detector
LanguageEnglish

Related product manuals