Mitsubishi Electric PMCR-50VHA-200D KIT

Questions and Answers

C
Carla HarrisAug 12, 2025
Why is my Mitsubishi Electric Controller heating system not reaching the set temperature?
- A
  andrea39Aug 12, 2025
  If your Mitsubishi Electric Controller's heating system isn't reaching the set temperature, first check if a prohibit, schedule, or holiday mode is active and adjust the settings as needed. Also, the room thermostat may be located in a place with a different temperature than the rest of the house. If so, reposition it to a more suitable room. If these steps don't resolve the issue, it might be due to incorrectly sized heat emitters, and you should contact your installer.
R
Robert OdomAug 19, 2025
What to do if an error code appears on my Mitsubishi Electric Controller display?
- P
  Paula Campbell MDAug 19, 2025
  If an error code appears on your Mitsubishi Electric Controller's display, it indicates an abnormal condition with either the indoor or outdoor unit. Note the error code number and contact your installer for assistance.
M
Michelle DrakeAug 27, 2025
Why is the Mitsubishi Electric PMCR-50VHA-200D KIT Temperature Controller remote display blank?
- S
  Susan GreenAug 27, 2025
  If the Mitsubishi Electric Temperature Controller remote display is blank, it could be due to a lack of power. First, check LED2 on the FTC2BR. If LED2 is lit, inspect the remote controller wiring for damage or contact failure. If LED2 is blinking or not lit, refer to points No. 5 or No. 4 respectively.
B
Brenda ElliottSep 3, 2025
Why am I getting cold water from my Mitsubishi Electric Controller taps (system with DHW tank)?
- M
  Michael MillerSep 3, 2025
  If you're experiencing cold water at the taps with your Mitsubishi Electric Controller's DHW tank system, it could be because all the hot water from the DHW tank has been used. Ensure the DHW mode is active and wait for the tank to reheat. If the issue persists, the heat pump or electric heaters may not be working, in which case you should contact your installer.